REMOVAL CAUTION / NOTICE / HINT HINT:
PROCEDURE 1. REMOVE FRONT WHEEL 2. REMOVE FRONT SHOCK ABSORBER WITH COIL SPRING LH (a) Remove the front shock absorber with coil spring (see page ). 3. DISCONNECT SKID CONTROL SENSOR WIRE (a) Remove the 2 bolts and disconnect the sensor wire from the steering knuckle and suspension upper arm. 4. DISCONNECT STEERING KNUCKLE LH (a) Support the front suspension lower arm LH with a jack. (b) Remove the clip and the nut.
5. REMOVE FRONT FENDER APRON SEAL LH (a) Using a clip remover, remove the 6 clips and apron seal. 6. REMOVE FRONT FENDER APRON SEAL REAR LH (a) Using a clip remover, remove the 5 clips and apron seal. 7. REMOVE FRONT SUSPENSION UPPER ARM ASSEMBLY (a) Remove the nut, bolt, 2 washers and suspension upper arm. |
Toyota Tundra Service Manual > Combination Meter: Removal
REMOVAL PROCEDURE 1. PRECAUTION NOTICE: After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work. Click here 2. D ...