DISASSEMBLY PROCEDURE 1. REMOVE REAR SPRING LEAF BUSH  (a) Put matchmarks on the bush on the front side of the vehicle. (1) Align the leaf spring with the openings and put matchmarks. (b) Use SST and a press, press out the bushes on both sides of the vehicle. SST: 09950-60010 09951-00350 SST: 09950-70010 09951-07150 NOTICE: Do not erase the matchmark on the leaf spring when removing the bush on the front side of the vehicle. |
Toyota Tundra Service Manual > Front Drive Shaft Assembly(for 4wd): Installation
INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedures for the RH side and LH side. The procedures listed below are for the LH side. A bolt without a torque specification is shown in the standard bolt chart (see page ). PROCEDURE 1. INSTALL FRONT DRIVE SHAFT ASSEMBLY LH (for Front Differ ...
