Toyota Tundra Service Manual: Inspection

INSPECTION

PROCEDURE

1. INSPECT TIRE

(a) Check the tires for wear and proper inflation pressure.

Standard cold tire inflation pressure:

Tire size

Front

kPa (kgf/cm2, psi)

Rear

kPa (kgf/cm2, psi)

P255/70R18

210 (2.1, 30)

230 (2.3, 33)

P275/65R18

P275/55R20

P255/70R18 (Spare Tire)

P275/65R18 (Spare Tire)

230 (2.3, 33)

(b) Using a dial indicator, check the tire runout.

Tire runout:

3.0 mm (0.118 in.) or less

2. ROTATE TIRE

(a) Rotate the tires as shown in the illustration.

Torque:

for Aluminum Wheel :

131 N·m {1336 kgf·cm, 97 ft·lbf}

for Steel Wheel :

209 N·m {2131 kgf·cm, 154 ft·lbf}

Text in Illustration

*a

Front of the Vehicle

3. INSPECT WHEEL BALANCE

(a) for Steel Wheel Type:

Check and adjust the off-the-car balance.

Standard Imbalance After Adjustment:

8.0 g (0.0180 lb) or less

NOTICE:

  • Use a cleaning detergent to remove dirt, oil and water from the surface where the balance weight is to be attached.
  • Do not touch the adhesive surface of the tape.
  • Attach a sticking-type balance weight to the flat surface (A) shown in the illustration.

    Width (A):

    25 mm (0.984 in.)

  • Push the balance weight firmly so that it securely adheres to the position.
  • Do not reuse the balance weight.

HINT:

  • For chrome type wheels, the inner side balance weight should be installed by clipping it to the rim.
  • If necessary, check and adjust the on-the-car balance.

(b) for Aluminum Wheel Type:

Check and adjust the off-the-car balance.

Standard Imbalance After Adjustment:

8.0 g (0.0180 lb) or less

NOTICE:

  • Use a cleaning detergent to remove dirt, oil and water from the surface where the balance weight is to be adhered.
  • Do not touch the sticking surface of the tape.
  • Adhere a sticking type balance weight to the flat surface (A) shown in the illustration.

    Width (A):

    25 mm (0.984 in.)

  • Push the balance weight firmly to adhere it to the position.
  • Do not reuse the balance weight.

HINT:

If necessary, check and adjust the on-the-car balance.

4. INSPECT FRONT AXLE HUB

(See page )

5. INSPECT REAR AXLE SHAFT

(See page )

    How To Proceed With Troubleshooting

    Precaution

    See More:

    Toyota Tundra Service Manual > Clearance Sonar Main Switch: Installation
    INSTALLATION PROCEDURE 1. INSTALL BACK SONAR OR CLEARANCE SONAR SWITCH ASSEMBLY (a) Attach the 2 claws to install the back sonar or clearance sonar switch assembly. 2. INSTALL NO. 2 SWITCH HOLE BASE 3. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH 4. INSTALL COWL SIDE TRIM BOARD LH 5. ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2022 Copyright www.ttundra.com
    0.0087