Toyota Tundra Service Manual: Precaution

PRECAUTION

1. REMOVAL AND INSTALLATION OF THE TIRE PRESSURE WARNING VALVE SUB-ASSEMBLY

(a) When installing a tire, make sure that the tire pressure warning valve and transmitter does not interfere with the tire bead in order to prevent damage to the sensor.

(b) After completing the installation, remove the valve core to rapidly release the air in the tire and check that the warning light comes on. If the warning light does not come on, the system may be defective.

(c) If there is an air leakage, tighten the nut to a torque of 4.0 N*m (41 kgf*cm, 35 in.*lbf) and push the valve core 2 or 3 times to remove any dirt attached to the valve core. If air continues to leak, replace the grommet, washer and nut. Use a manufacturer-specified cap.

(d) When installing the tire pressure warning valve and transmitter, check that the rim, grommet, washer and nut are clean. Use a manufacturer-specified cap.

(e) When inflating the tire, first install the tire pressure valve straight onto the stem of the tire pressure warning valve and transmitter.

2. TIRE AND WHEEL REPLACEMENT OR TIRE ROTATION

(a) If replacing a tire, be sure to check the grommet of the tire pressure warning valve and transmitter for damage. If the grommet is damaged, replace the grommet, washer, and nut.

(b) If tires and wheels are replaced, register the transmitter ID (see page ).

    Inspection

    Tire Pressure Warning Receiver

    See More:

    Toyota Tundra Service Manual > Front Door Lock(for Crewmax): Installation
    INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedures for the LH side and RH side. The procedures listed below are for the LH side. A bolt without a torque specification is shown in the standard bolt chart (See page ). PROCEDURE 1. INSTALL FRONT DOOR INSIDE LOCKING CABLE ASSEMBLY LH 2. ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2022 Copyright www.ttundra.com
    0.018