Toyota Tundra Service Manual: Tire Pressure Monitor ECU Communication Stop (C2179/79)

Toyota Tundra Service Manual / Engine, Hybrid System / Tire And Wheel / Tire Pressure Warning System / Tire Pressure Monitor ECU Communication Stop (C2179/79)

DESCRIPTION

The main body ECU (multiplex network body ECU) sends signals to the tire pressure warning ECU and receiver via a direct line.

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

Note

C2179/79

Tire Pressure Monitor ECU Communication Stop

Communication between the main body ECU (multiplex network body ECU) and tire pressure warning ECU and receiver is interrupted for 10 seconds or more.

  • Main body ECU (Multiplex network body ECU)
  • Wire harness or connector
  • Tire pressure warning ECU and receiver

-

WIRING DIAGRAM

CAUTION / NOTICE / HINT

NOTICE:

  • When replacing the tire pressure warning ECU and receiver, read the transmitter IDs stored in the old ECU using the Techstream and write them down before removal.
  • It is necessary to perform initialization after registration of the transmitter IDs into the tire pressure warning ECU and receiver after the ECU has been replaced.

PROCEDURE

1.

CHECK HARNESS AND CONNECTOR (TIRE PRESSURE WARNING ECU AND RECEIVER - MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU))

(a) Disconnect the P21 tire pressure warning ECU and receiver connector.

(b) Disconnect the J165 main body ECU (multiplex network body ECU) connector.

(c) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

P21-5 (PRG) - J165-5 (PRG)

Always

Below 1 Ω

P21-5 (PRG) or J165-5 (PRG) - Body ground

Always

10 kΩ or higher

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

OK

2.

REPLACE TIRE PRESSURE WARNING ECU AND RECEIVER

(a) Replace the tire pressure warning ECU and receiver.

Click here

NEXT

3.

CHECK DTC OUTPUT

(a) Clear the DTCs.

Click here

(b) Turn the ignition switch off.

(c) Turn the ignition switch to ON.

(d) Check for DTCs.

Click here

OK:

DTC C2179/79 is not output.

OK

END

NG

REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)

    Initialization not Completed (C2177/77)

    Initialization Switch (for Test Mode DTC) (C2198/98)

    See More:

    Toyota Tundra Service Manual > Automatic Transmission System: Terminals Of Ecm
    TERMINALS OF ECM 1. CHECK ECM HINT: The standard voltage at each ECM terminal is shown in the table below. In the table, first follow the information under "Condition". Look under "Terminal No. (Symbol)" for the terminals to inspect. The standard voltage between the terminals is shown under "Specifi ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2024 Copyright www.ttundra.com
    0.0335