DESCRIPTION When the tire pressure warning reset switch is turned on and off 3 times within 3 seconds (pressed → released → pressed → released → pressed → released), the tire pressure warning ECU and receiver switches to ID registration mode according to the automatic ID registration function. When the system enters ID registration mode, the tire pressure warning light blinks 3 times as an answer back function. The main body ECU (multiplex network body ECU) receives signals from the combination meter assembly via the CAN communication line. WIRING DIAGRAM Click here PROCEDURE
(a) Perform the test mode inspection and check for the tire pressure warning reset switch check item (DTC C2198/98). Click here
|
Toyota Tundra Service Manual > Roof Drip Side Finish Moulding: Removal
REMOVAL CAUTION / NOTICE / HINT HINT: Use the same procedures for the RH side and LH side. The procedures listed below are for the LH side. When removing the moulding, heat the vehicle body and moulding using a heat light. When replacing a clip, heat the vehicle body and clip using a heat light. Sta ...