DESCRIPTION This DTC is detected when a short to B+ is detected in the solenoid coil drive circuit.
WIRING DIAGRAM Refer to DTCs P17A5 and P17A6 (See page PROCEDURE
![]() (a) Disconnect the 4 wheel drive control ECU connector. (b) Measure the voltage according to the value(s) in the table below. Standard Voltage:
(a) Disconnect the A26 4 wheel drive control ECU connector. (b) Disconnect the D67 transfer shift actuator assembly connector. (c) Measure the voltage according to the value(s) in the table below. Standard Voltage:
![]() (a) Disconnect the A solenoid coil sub-assembly connector. (b) Measure the voltage according to the value(s) in the table below. Standard Voltage:
|
Toyota Tundra Service Manual > Vehicle Stability Control System: Low Power Supply Voltage Malfunction (C1241)
DESCRIPTION If a malfunction is detected in the power supply circuit, the skid control ECU (brake actuator assembly) stores this DTC and the fail-safe function prohibits ABS operation. This DTC is stored when the +BS terminal voltage meets one of the DTC detection conditions due to a malfunction in ...