Toyota Tundra Service Manual: Installation

INSTALLATION

CAUTION / NOTICE / HINT

HINT:

A bolt without a torque specification is shown in the standard bolt chart.

Click here

PROCEDURE

1. INSTALL NETWORK GATEWAY ECU

(a) for Floor Shift Type:

(1) Install the network gateway ECU with the 2 nuts.

Torque:

7.5 N·m {76 kgf·cm, 66 in·lbf}

(2) Connect the connector.

(b) for Column Shift Type:

(1) Install the network gateway ECU and shift lock control ECU with the 2 nuts.

Torque:

7.5 N·m {76 kgf·cm, 66 in·lbf}

(2) Connect the 2 connectors.

(3) Attach the clamp.

2. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY RH

(a) for Column Shift Type:

Click here

(b) for Floor Shift Type:

HINT:

Use the same procedure described for Column Shift Type.

3. INSTALL LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY

Click here

4. INSTALL LOWER INSTRUMENT PANEL

(a) for Column Shift Type:

Click here

(b) for Floor Shift Type:

HINT:

Use the same procedure described for Column Shift Type.

5. INSTALL INSTRUMENT SIDE PANEL RH

(a) for Column Shift Type:

Click here

(b) for Floor Shift Type:

HINT:

Use the same procedure described for Column Shift Type.

6. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

(a) for Column Shift Type:

Click here

(b) for Floor Shift Type:

HINT:

Use the same procedure described for Column Shift Type.

7. INSTALL COWL SIDE TRIM BOARD RH

(a) for Double Cab:

HINT:

Use the same procedure described for the LH side.

Click here

(b) for CrewMax:

HINT:

Use the same procedure described for Double Cab.

8. INSTALL FRONT DOOR SCUFF PLATE RH

(a) for Double Cab:

HINT:

Use the same procedure described for the LH side.

Click here

(b) for CrewMax:

HINT:

Use the same procedure described for the LH side.

Click here

9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click here

10. PERFORM DIAGNOSTIC SYSTEM CHECK

Click here

11. CHECK SRS WARNING LIGHT

Click here