REMOVAL PROCEDURE 1. PRECAUTION NOTICE: After
turning the ignition switch off, waiting time may be required before
disconnecting the cable from the battery terminal. Therefore, make sure
to read the disconnecting the cable from the battery terminal notice
before proceeding with work (See page 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system. 3. REMOVE V-BANK COVER SUB-ASSEMBLY 4. REMOVE AIR CLEANER ASSEMBLY 5. REMOVE NO. 1 ENGINE UNDER COVER 6. REMOVE FAN AND GENERATOR V BELT 7. DRAIN POWER STEERING FLUID 8. DISCONNECT WIRE HARNESS CLAMP
9. DISCONNECT NO. 1 OIL RESERVOIR TO PUMP HOSE
10. DISCONNECT POWER STEERING OIL PRESSURE SENSOR CONNECTOR
11. DISCONNECT PRESSURE FEED TUBE
(b) Remove the gasket. 12. REMOVE VANE PUMP ASSEMBLY
|
Toyota Tundra Service Manual > Power Door Lock Control System: Problem Symptoms Table
PROBLEM SYMPTOMS TABLE HINT: Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the ...