DISASSEMBLY PROCEDURE 1. FIX VANE PUMP ASSEMBLY
2. REMOVE POWER STEERING SUCTION PORT UNION
(b) Using a screwdriver, remove the O-ring from the suction port union. 3. REMOVE FLOW CONTROL VALVE
(b) Remove the O-ring from the pressure port union. (c) Remove the flow control valve and compression spring. 4. REMOVE VANE PUMP REAR HOUSING
5. REMOVE VANE PUMP SHAFT WITH VANE PUMP PULLEY
(b) Remove the vane pump shaft with vane pump pulley. NOTICE: Be careful not to drop or damage the vane pump shaft with vane pump pulley. If it is damaged, replace the vane pump assembly. 6. REMOVE VANE PUMP ROTOR
(b) Remove the vane pump rotor. 7. REMOVE VANE PUMP CAM RING
8. REMOVE VANE PUMP FRONT SIDE PLATE
9. REMOVE VANE PUMP HOUSING OIL SEAL
|
Toyota Tundra Service Manual > 1ur-fe Engine Control: Fuel Pump Relay
On-vehicle InspectionON-VEHICLE INSPECTION PROCEDURE 1. REMOVE FUEL PUMP RELAY (F/PMP) (a) Remove the fuel pump relay from the engine room relay block. 2. INSPECT FUEL PUMP RELAY (a) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Conditio ...