REMOVAL PROCEDURE 1. PRECAUTION NOTICE: After
turning the ignition switch off, waiting time may be required before
disconnecting the cable from the battery terminal. Therefore, make sure
to read the disconnecting the cable from the battery terminal notice
before proceeding with work (See page 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system. NOTICE: Some systems need to be initialized after the cable is reconnected (See page
3. REMOVE V-BANK COVER SUB-ASSEMBLY 4. REMOVE NO. 1 ENGINE UNDER COVER 5. REMOVE AIR CLEANER ASSEMBLY 6. REMOVE FAN AND GENERATOR V BELT 7. DRAIN POWER STEERING FLUID 8. DISCONNECT WIRE HARNESS CLAMP
9. DISCONNECT NO. 1 OIL RESERVOIR TO PUMP HOSE
10. DISCONNECT POWER STEERING OIL PRESSURE SENSOR CONNECTOR
11. DISCONNECT PRESSURE FEED TUBE
(b) Remove the gasket. 12. REMOVE VANE PUMP ASSEMBLY
|
Toyota Tundra Service Manual > Engine Immobiliser System (w/o Smart Key System): Data List / Active Test
DATA LIST / ACTIVE TEST DATA LIST HINT: Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be dis ...