DIAGNOSIS SYSTEM 1. DESCRIPTION (a) When troubleshooting a vehicle with the diagnostic system, the only difference from the usual troubleshooting procedure is connecting the Techstream to the vehicle and reading various data output from the multiplex tilt and telescopic ECU. The multiplex tilt and telescopic ECU stores DTCs when the ECU detects a malfunction in itself or in its circuits. To check the DTCs, connect the Techstream to the DLC3 on the vehicle. The Techstream enables the DTCs to be cleared, several actuators to be activated, and the freeze frame data and various forms of steering data to be checked. 2. CHECK DLC3 (a) Check the DLC3. Click here
|
Toyota Tundra Service Manual > Engine Unit: Inspection
INSPECTION PROCEDURE 1. INSPECT CYLINDER HEAD SET BOLT (a) Using a vernier caliper, measure the length of the cylinder head bolt from the seat to the end. Standard length: 141.3 to 142.7 mm (5.56 to 5.62 in.) Maximum length: 143.7 mm (5.66 in.) If the length is more than the maximum, replace the cyl ...
