Toyota Tundra Service Manual: Inspection

Toyota Tundra Service Manual / Steering / Steering Column / Steering Column Assembly(for Manual Tilt And Manual Telescopic Steering Column) / Inspection

INSPECTION

PROCEDURE

1. INSPECT STEERING COLUMN ASSEMBLY

(a) Measure the length of the steering main shaft.

Standard length(A):

529.5 mm (1.74 ft.)

(b) Inspect the bushings.

(1) Check that the 2 bushings are securely installed to the steering column assembly.

Text in Illustration

*1

Bushing

If the bushings are missing or damaged, replace the steering column assembly with a new one.

(2) Check the 2 bushings for deformation and damage.

If the bushings are deformed or damaged, replace the steering column assembly with a new one.

(c) Inspect the capsules.

(1) Check that the 2 capsules are securely installed to the steering column assembly as shown in the illustration.

Standard Dimension:

A

B

3 mm (0.118 in.)

10 mm (0.394 in.)
Text in Illustration

*1

Capsule

If the capsules are not positioned as specified, replace the steering column assembly with a new one.

(2) Check the 2 capsules for deformation and damage.

If either of the capsules is deformed, loose, missing or damaged, replace the steering column assembly with a new one.

    Disassembly

    Installation

    See More:

    Toyota Tundra Service Manual > Wireless Door Lock Control System: Diagnosis System
    DIAGNOSIS SYSTEM CHECK DLC3 (a) Check the DLC3. Click here INSPECT BATTERY VOLTAGE (a) Measure the vehicle battery voltage. Standard voltage: 11 to 14 V If the voltage is below 11 V, recharge or replace the battery. SELF-DIAGNOSTIC MODE (a) Connect the Techstream to the DLC3. (b) Turn the ignition s ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2026 Copyright www.ttundra.com
    0.0198