Toyota Tundra Service Manual: Reassembly

REASSEMBLY

PROCEDURE

1. INSTALL STEERING COLUMN BRACKET SPACER

(a) Fix the steering column in a vise between aluminum plates or a cloth. Then install the steering column bracket spacer to the steering column.

NOTICE:

  • Install the steering column bracket spacer so that it is facing in the direction shown in the illustration.
  • When using a vise, do not overtighten it.

2. INSTALL IGNITION SWITCH ASSEMBLY

(a) Attach the 2 claws to install the ignition switch to the switch bracket.

3. INSTALL KEY INTERLOCK SOLENOID

(a) Install the key interlock solenoid to the switch bracket with the 2 screws.

4. INSTALL UNLOCK WARNING SWITCH ASSEMBLY

(a) Attach the 2 claws to install the unlock warning switch to the switch bracket.

5. INSTALL IGNITION SWITCH LOCK CYLINDER

(a) Check that the ignition switch lock cylinder is in the ACC position.

(b) Install the ignition switch lock cylinder to the steering lock sub-assembly.

Text in Illustration

*a

LOCK

*b

ACC

*c

ON

*d

START

(c) Check that the ignition switch lock cylinder assembly is securely installed.

6. INSPECT STEERING LOCK OPERATION

7. INSTALL UPPER STEERING COLUMN WITH SWITCH BRACKET ASSEMBLY

(a) Temporarily install the upper steering column with switch bracket and steering lock bracket with 2 new tapered-head bolts.

(b) Tighten the 2 tapered-head bolts until the bolt heads break off.

8. INSTALL TRANSPONDER KEY AMPLIFIER (w/ Engine Immobiliser System)

(a) Align the transponder key amplifier with the installation position of the switch bracket with the amplifier inclined.

(b) Push the transponder key amplifier upward and install it to the switch bracket.

NOTICE:

Do not push the amplifier up with excessive force.

9. INSTALL KEY CYLINDER LIGHT ASSEMBLY (w/o Engine Immobiliser System)

(a) Align the key cylinder light with the installation position of the switch bracket with the key cylinder light inclined.

(b) Push the key cylinder light upward and install it to the switch bracket.

NOTICE:

Do not push the key cylinder light up with excessive force.

    Installation

    Removal

    See More:

    Toyota Tundra Service Manual > Air Conditioning System(for Manual Air Conditioning System): ECU Power Source Circuit
    DESCRIPTION This circuit provides power to operate the air conditioning amplifier. WIRING DIAGRAM PROCEDURE 1. INSPECT FUSE (ECU-B NO.2) (a) Remove the ECU-B NO.2 fuse from the driver side junction block. (b) Measure the resistance according to the value(s) in the table below. Standard resistance: T ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2022 Copyright www.ttundra.com
    0.0175