Toyota Tundra Service Manual: Inspection

Toyota Tundra Service Manual / Steering / Steering Column / Steering Column Assembly(for Manual Tilt) / Inspection

INSPECTION

PROCEDURE

1. INSPECT STEERING COLUMN ASSEMBLY

(a) Measure the length of the steering main shaft.

Standard length (A):

529.5 mm (1.74 ft.)

(b) Inspect the bushings.

(1) Check that the 2 bushings are securely installed to the steering column assembly.

Text in Illustration

*1

Bushing

If the bushings are missing or damaged, replace the steering column assembly with a new one.

(2) Check the 2 bushings for deformation and damage.

If the bushings are deformed or damaged, replace the steering column assembly with a new one.

(c) Inspect the capsules.

(1) Check that the 2 capsules are securely installed to the steering column assembly as shown in the illustration.

Standard Dimension:

A

B

3 mm (0.118 in.)

10 mm (0.394 in.)
Text in Illustration

*1

Capsule

If the capsules are not positioned as specified, replace the steering column assembly with a new one.

(2) Check the 2 capsules for deformation and damage.

If either of the capsules is deformed, loose, missing or damaged, replace the steering column assembly with a new one.

    Disassembly

    Installation

    See More:

    Toyota Tundra Service Manual > Air Pump: On-vehicle Inspection
    ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT AIR PUMP ASSEMBLY (a) Start the engine and warm it up. (b) Turn the ignition switch off. (c) Connect the 400 A probe of an ammeter to the (+) wire of the air pump assembly. (d) Connect the Techstream to the DLC3. (e) Turn the ignition switch to ON and turn ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2026 Copyright www.ttundra.com
    0.0126