Toyota Tundra Service Manual: Air Mix Damper Control Servo Motor Circuit (Passenger Side) (B1441/41)

Toyota Tundra Service Manual / Vehicle Interior / Air Conditioning / Air Conditioning System(for Automatic Air Conditioning System) / Air Mix Damper Control Servo Motor Circuit (Passenger Side) (B1441/41)

DESCRIPTION

The air mix damper servo motor (for passenger side) sends pulse signals to inform the air conditioning amplifier of the damper position. The air conditioning amplifier activates the motor (normal, reverse) based on the signals to move the air mix damper (for passenger side) to any position. As a result the amount of air that has passed through the evaporator and is now passing through the heater core is adjusted, and the temperature of the air blowing toward the passenger side is controlled.

DTC Code

DTC Detection Condition

Trouble Area

B1441/41

Air mix damper position sensor value does not change even if air conditioning amplifier operates air mix servo motor

  • Air mix servo motor (for passenger side)
  • Air conditioning harness
  • Air conditioning amplifier

WIRING DIAGRAM

PROCEDURE

1.

READ VALUE USING TECHSTREAM (AIR MIX SERVO MOTOR TARGET PULSE (for Passenger Side))

(a) Use the Data List to check if the servo motor is functioning properly.

Air Conditioner

Tester Display

Measurement Item / Range

Normal Condition

Diagnostic Note

Air Mix Servo Targ Pulse (P)

Passenger side air mix servo motor target pulse /

Min.: 0, Max.: 255

MAX. COLD: 105 (pulse)

MAX. HOT: 6 (pulse)

-

OK:

The display is as specified in the normal condition.

Result

Result

Proceed to

OK (Checking from the DTC)

A

OK (Checking from the PROBLEM SYMPTOMS TABLE)

B

NG

C

B

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE

C

REPLACE AIR CONDITIONING AMPLIFIER

A

2.

REPLACE AIR MIX SERVO MOTOR (for Passenger Side)

(a) Temporarily replace the air mix servo motor with a new one (see page ).

HINT:

Since the servo motor cannot be inspected while it is removed from the vehicle, replace the servo motor with a new one and check that the condition returns to normal.

NEXT

3.

CHECK FOR DTC

(a) Clear the DTC (see page ).

(b) Check for DTC (see page ).

OK:

DTC is not output.

OK

END (AIR MIX SERVO MOTOR IS DEFECTIVE)

NG

4.

REPLACE AIR CONDITIONING HARNESS

(a) Replace the air conditioning harness.

NEXT

5.

CHECK FOR DTC

(a) Clear the DTC (see page ).

(b) Check for DTC again (see page ).

OK:

DTC is not output.

OK

END (AIR CONDITIONING HARNESS IS DEFECTIVE)

NG

REPLACE AIR CONDITIONING AMPLIFIER

    Solar Sensor Circuit (Driver Side) (B1424/24)

    Air Inlet Damper Control Servo Motor Circuit (B1442/42)

    See More:

    Toyota Tundra Service Manual > Network Gateway Ecu: Installation
    INSTALLATION CAUTION / NOTICE / HINT HINT: A bolt without a torque specification is shown in the standard bolt chart. Click here PROCEDURE 1. INSTALL NETWORK GATEWAY ECU (a) for Floor Shift Type: (1) Install the network gateway ECU with the 2 nuts. Torque: 7.5 N·m {76 kgf·cm, 66 in·lbf} (2) Conne ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2024 Copyright www.ttundra.com
    0.0339