Toyota Tundra Service Manual: Disassembly

DISASSEMBLY

PROCEDURE

1. REMOVE COOLER COMPRESSOR BRACKET

(a) Detach the harness clamp.

(b) Remove the screw and the cooler compressor bracket.

2. REMOVE MAGNET CLUTCH ASSEMBLY

(a) Clamp the cooler compressor assembly in a vise.

(b) Using SST, hold the magnet clutch hub.

SST: 09985-00270

(c) Remove the bolt, magnet clutch hub and magnet clutch washer(s).

HINT:

There is no set number of magnet clutch washers since they are used for adjusting.

(d) Using a snap ring expander, remove the snap ring and the magnet clutch rotor. NOTICE: Do not damage the seal cover of the bearing when removing the snap ring.

(e) Disconnect the connector.

(f) Using a snap ring expander, remove the snap ring and magnet clutch stator.