Toyota Tundra Service Manual: Inspection

INSPECTION

PROCEDURE

1. INSPECT NO. 1 COOLER THERMISTOR

(a) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

1 - 2

-10°C (14°F)

7.30 to 9.10 kΩ

-5°C (23°F)

5.65 to 6.95 kΩ

0°C (32°F)

4.40 to 5.35 kΩ

5°C (41°F)

3.40 to 4.15 kΩ

10°C (50°F)

2.70 to 3.25 kΩ

15°C (59°F)

2.14 to 2.58 kΩ

20°C (68°F)

1.71 to 2.05 kΩ

25°C (77°F)

1.38 to 1.64 kΩ

30°C (86°F)

1.11 to 1.32 kΩ

NOTICE:

  • Even slightly touching the sensor may change the resistance value. Be sure to hold the connector of the sensor.
  • When measuring, the sensor temperature must be almost the same as the ambient temperature.

HINT:

As the temperature increases, the resistance decreases (see the graph).

Text in Illustration

*1

Sensor

*a

Component without harness connected

(No. 1 Cooler Thermistor)

*b

Resistance (kΩ)

*c

Temperature (°C (°F))

If the result is not as specified, replace the sensor.

    Components

    Installation

    See More:

    Toyota Tundra Service Manual > 1ur-fe Engine Mechanical: Rear Crankshaft Oil Seal
    ComponentsCOMPONENTS ILLUSTRATION *1 DRIVE PLATE AND RING GEAR SUB-ASSEMBLY *2 REAR CRANKSHAFT OIL SEAL *3 CRANKSHAFT ANGLE SENSOR ROTOR *4 REAR DRIVE PLATE SPACER *a BLACK: x 1 SILVER: x 5 - - N*m (kgf*cm, ft.*lbf): Specified torque ● Non-reusable part MP grease ★ Precoated part *T1 1st: 30 N* ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2022 Copyright www.ttundra.com
    0.0092