INSTALLATION PROCEDURE 1. INSTALL NO. 1 COOLER THERMISTOR NOTICE: If reusing the evaporator, do not insert the No. 1 cooler thermistor into a location where the No. 1 cooler thermistor was previously inserted. Insert the No. 1 cooler thermistor within range C shown in the illustration. (a) Install the No. 1 cooler thermistor to the No. 1 cooler evaporator sub-assembly as shown in the illustration.
2. INSTALL NO. 1 COOLER EVAPORATOR SUB-ASSEMBLY (a) Install the No. 1 cooler evaporator sub-assembly to the blower assembly. 3. INSTALL BLOWER ASSEMBLY (a) Attach the 3 claws to install the blower assembly. (b) Install the 6 screws.
(d) Attach the 3 claws to install the heater clamp. 4. INSTALL AIR CONDITIONING AMPLIFIER ASSEMBLY
5. INSTALL NO. 3 AIR DUCT SUB-ASSEMBLY
6. INSTALL AIR CONDITIONING UNIT (See page ). |
Toyota Tundra Service Manual > Main Body Ecu: Installation
INSTALLATION CAUTION / NOTICE / HINT NOTICE: The main body ECU (multiplex network body ECU) is not reusable. Before replacing the main body ECU (multiplex network body ECU), refer to Service Bulletin. PROCEDURE 1. INSTALL MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) NOTICE: Make sure that the connecti ...