Toyota Tundra Service Manual: Removal

REMOVAL

PROCEDURE

1. REMOVE AIR CONDITIONING UNIT

(See page ).

2. REMOVE NO. 3 AIR DUCT SUB-ASSEMBLY

3. REMOVE AIR CONDITIONING AMPLIFIER ASSEMBLY

4. REMOVE BLOWER ASSEMBLY

(a) Detach the 3 claws and remove the heater clamp.

(b) Remove the No. 1 cooling unit packing and No. 2 cooling unit packing.

5. REMOVE NO. 1 COOLER EVAPORATOR SUB-ASSEMBLY

(a) Remove the No. 1 cooler evaporator sub-assembly from the blower assembly.

6. REMOVE NO. 1 COOLER THERMISTOR

(a) Remove the No. 1 cooler thermistor from the No. 1 cooler evaporator sub-assembly.

Toyota Tundra Service Manual > Blind Spot Monitor System: Blind Spot Monitor Master Module Beam Axis Inspection Incomplete (C1ABB)
DESCRIPTION This DTC is stored when a beam axis inspection has not been performed for the blind spot monitor sensor RH. HINT: This DTC is always stored after replacing a blind spot monitor sensor. The purpose of this DTC is to ensure that beam axis inspection is performed. Completing the beam axis i ...

Toyota Tundra Owners Manual