Toyota Tundra Service Manual: Magnetic Clutch Relay

Toyota Tundra Service Manual / Vehicle Interior / Air Conditioning / Magnetic Clutch Relay

On-vehicle Inspection

ON-VEHICLE INSPECTION

PROCEDURE

1. INSPECT MAGNETIC CLUTCH RELAY (MG CLT)

(a) Remove the magnetic clutch relay from the engine room relay block.

(b) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

3 - 5

Battery voltage is not applied between terminals

10 kΩ or higher

Battery voltage is applied to terminals 1 and 2

Below 1 Ω
  • If the result is not as specified, replace the magnet clutch relay.

(c) Install the magnetic clutch relay to the engine room relay block.

    Removal

    Pressure Switch

    See More:

    Toyota Tundra Service Manual > Room Light Switch: Inspection
    INSPECTION PROCEDURE 1. INSPECT INTERIOR ROOM LIGHT SWITCH ASSEMBLY (a) Check the resistance. (1) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Switch Condition Specified Condition 6 (FCTY) - 11 (FLMP) Interior room light switch DOOR Belo ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2026 Copyright www.ttundra.com
    0.0336