Components COMPONENTS ILLUSTRATION ![]()
Installation INSTALLATION PROCEDURE 1. INSTALL DOOR CONTROL AND TIRE PRESSURE MONITORING SYSTEM RECEIVER ASSEMBLY (a) Attach the 2 guides to install the door control and tire pressure monitoring system receiver assembly with the bolt. Torque: 7.0 N·m {71 kgf·cm, 62 in·lbf} NOTICE:
(b) Connect the connector. 2. INSTALL ROOF HEADLINING ASSEMBLY Click here 3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL NOTICE: When disconnecting the cable, some systems need to be initialized after the cable
is reconnected (See page 4. REGISTRATION OF TRANSMITTER ID Click here 5. INSPECT TIRE PRESSURE WARNING SYSTEM Click here 6. PERFORM INITIALIZATION Click here Removal REMOVAL CAUTION / NOTICE / HINT NOTICE:
PROCEDURE 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL NOTICE: When disconnecting the cable, some systems need to be initialized after the cable
is reconnected (See page 2. REMOVE ROOF HEADLINING ASSEMBLY Click here 3. REMOVE DOOR CONTROL AND TIRE PRESSURE MONITORING SYSTEM RECEIVER ASSEMBLY ![]() (a) Disconnect the connector. (b) Remove the bolt. (c) Detach the 2 guides and remove the door control and tire pressure monitoring system receiver assembly. NOTICE:
|
Toyota Tundra Service Manual > Touch Select 2-4 And High-low System: Dtc Check / Clear
DTC CHECK / CLEAR 1. CHECK DTC (a) Check the DTCs. (1) Connect the Techstream to the DLC3. (2) Turn the ignition switch to ON. (3) Turn the Techstream on. (4) Read the DTCs following the prompts on the Techstream screen. Enter the following menus: Chassis / Four Wheel Drive / Trouble Codes. (5) Chec ...