INSPECTION PROCEDURE 1. INSPECT DOOR CONTROL TRANSMITTER MODULE SET SUB-ASSEMBLY (a) Inspect operation of the door control transmitter module set sub-assembly. (1) Remove the transmitter battery from the door control transmitter module set sub-assembly. Click here
(3) From outside the vehicle, approximately 1 m (3.28 ft) from the driver door outside door handle, test the door control transmitter module set sub-assembly by pointing its key plate at the vehicle and pressing a door control transmitter module set sub-assembly switch. OK: The door lock can be operated via the door control transmitter module set sub-assembly.
(b) Inspect the transmitter battery capacity. (1) Remove the transmitter battery from the door control transmitter module set sub-assembly that does not operate. Attach a lead wire (0.6 mm (0.0236 in.) in diameter or less including wire sheath) with tape or equivalent to the negative terminal. Click here NOTICE: Do not wrap the lead wire around a terminal, wedge it between the terminals, or solder it. A terminal may be deformed or damaged, and the transmitter battery will not be able to be installed correctly.
|
Toyota Tundra Service Manual > Theft Deterrent System: Problem Symptoms Table
PROBLEM SYMPTOMS TABLE HINT: Troubleshooting of the theft deterrent system is based on the premise that the power door lock control system and the wireless door lock control system are operating normally. Accordingly, before troubleshooting the theft deterrent system, first make certain that the pow ...