DATA LIST / ACTIVE TEST 1. READ DATA LIST HINT: Using the Techstream to read the Data List allows the values or states of switches, sensor, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time. NOTICE: In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not. (a) Connect the Techstream to the DLC3. (b) Turn the ignition switch ON. (c) Turn the Techstream on. (d) Enter the following menus: Body / Main Body / Data List. (e) According to the display on tester, read the "Data List". Main Body
|
Toyota Tundra Service Manual > Oil Pump: Installation
INSTALLATION PROCEDURE 1. INSTALL WATER INLET PIPE (a) Apply soapy water to 2 new O-rings and install them to the water inlet pipe. (b) Install the water inlet pipe to the No. 1 heat exchanger cover. 2. INSTALL TIMING CHAIN COVER SUB-ASSEMBLY (a) Apply a light coat of engine oil to a new oil pump ga ...
