DESCRIPTION This DTC is stored when a malfunction occurs in a connected device.
PROCEDURE
(a) Disconnect the USB device or "iPod" from the No. 1 stereo jack adapter assembly. (b) Turn the ignition switch off. HINT: When this DTC has been stored, it is necessary to turn off the ignition switch to make it possible for the vehicle to recognize a new device when it is connected. (c) Turn the ignition switch to ACC. (d) Connect a known good USB device or "iPod" to the No. 1 stereo jack adapter assembly. HINT:
(a) Clear the DTCs (See page ). (b) Check for DTCs (See page ). OK: No DTCs are output. Result
|
Toyota Tundra Service Manual > Ultrasonic Sensor(for Rear Side): Inspection
INSPECTION PROCEDURE 1. INSPECT NO. 2 ULTRASONIC SENSOR (a) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Condition Specified Condition 1 (BI) - 5 (EI) Always 10 kΩ or higher 1 (BI) - 2 (BO) Always 10 kΩ or higher 3 (SI) - 4 (SO) Always ...