INSTALLATION PROCEDURE 1. INSTALL REAR DOOR INSIDE LOCKING CABLE ASSEMBLY LH
2. INSTALL REAR DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY LH
3. INSTALL REAR DOOR LOCK ASSEMBLY LH
4. INSTALL REAR DOOR GLASS SUB-ASSEMBLY LH
5. INSTALL REAR DOOR REAR LOWER WINDOW FRAME SUB-ASSEMBLY LH
6. INSTALL REAR DOOR GLASS RUN LH
7. INSTALL REAR DOOR SERVICE HOLE COVER LH
8. INSTALL REAR NO. 2 DOOR TRIM BRACKET
9. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY LH
10. INSTALL REAR DOOR ARMREST COVER LH 11. INSTALL REAR DOOR FRAME GARNISH LH
12. INSTALL REAR UPPER DOOR ARMREST BASE PANEL LH
13. INSTALL REAR DOOR INSIDE HANDLE BEZEL PLUG LH
14. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
Toyota Tundra Service Manual > Rear Brake: Inspection
INSPECTION PROCEDURE 1. CHECK PAD LINING THICKNESS (a) Using a ruler, measure the pad lining thickness. Standard thickness: 12.0 mm (0.472 in.) Minimum thickness: 1.0 mm (0.0394 in.) If the pad lining thickness is less than the minimum, replace the pad. HINT: Be sure to check the wear on the rear di ...
