Toyota Tundra Service Manual: Inspection

INSPECTION

PROCEDURE

1. INSPECT UNLOCK WARNING SWITCH ASSEMBLY

(a) Measure the resistance according to the value(s) in the table below.

Standard resistance:

Tester Connection

Condition

Specified Condition

1 - 2

Switch free (Key removed)

10 kΩ or higher

Switch pushed (Key set)

Below 1 Ω

If the result is not as specified, replace the unlock warning switch assembly.

Text in Illustration

*a

Component without harness connected

(Unlock Warning Switch Assembly)

    Components

    Installation

    See More:

    Toyota Tundra Service Manual > 1ur-fe Starting: Acc Cut Relay
    On-vehicle InspectionON-VEHICLE INSPECTION PROCEDURE 1. REMOVE ACC CUT RELAY (a) Remove the clip. (b) Detach the 2 clips and remove the cowl side trim board RH. (c) Remove the relay. 2. INSPECT ACC CUT RELAY (a) Measure the resistance according to the value(s) in the table below. Standard Resistanc ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2025 Copyright www.ttundra.com
    0.0099