DIAGNOSIS SYSTEM CHECK DLC3 (a) Check the DLC3. Click here INSPECT BATTERY VOLTAGE (a) Measure the vehicle battery voltage. Standard voltage: 11 to 14 V If the voltage is below 11 V, recharge or replace the battery. SELF-DIAGNOSTIC MODE (a) Connect the Techstream to the DLC3. (b) Turn the ignition switch to ON. (c) Turn the Techstream on. (d) Enter the following menus: Body Electrical / Main Body / Utility / Wireless Door Lock Diagnosis Mode. (e) Proceed to the next step in accordance with the prompts on the Techstream screen. (f) Check that the system has switched to self-diagnostic mode by checking the interior light output pattern. (g) Check that the system has switched to self-diagnostic mode by checking the wireless door lock buzzer output pattern. (h) Check the diagnostic outputs when a door control transmitter assembly switch is pressed. The diagnostic outputs can be checked by the interior light and wireless door lock buzzer patterns. Result
|
Toyota Tundra Service Manual > Rear Door(for Crewmax): Disassembly
DISASSEMBLY CAUTION / NOTICE / HINT HINT: Use the same procedures for the RH side and LH side. The procedures listed below are for the LH side. PROCEDURE 1. PRECAUTION NOTICE: After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal ...