Toyota Tundra Service Manual: On-vehicle Inspection

ON-VEHICLE INSPECTION

PROCEDURE

1. INSPECT FRONT DOOR PANEL SUB-ASSEMBLY LH

(a) Check that the clearance measurements of areas A to J are within the standard range.

Standard measurement:

Area	Specified Condition	Area	Specified Condition
A	3.7 to 6.7 mm (0.146 to 0.264 in.)	F	0.8 to 3.8 mm (0.0315 to 0.150 in.)
B	-1.5 to 1.5 mm (-0.0591 to 0.0591 in.)	G	3.7 to 6.7 mm (0.146 to 0.264 in.)
C	3.7 to 6.7 mm (0.146 to 0.264 in.)	H	0.8 to 3.8 mm (0.0315 to 0.150 in.)
D	0.9 to 3.9 mm (0.0354 to 0.154 in.)	I	4.7 to 7.7 mm (0.185 to 0.303 in.)
E	3.7 to 6.7 mm (0.146 to 0.264 in.)	J	-1.5 to 1.5 mm (-0.0591 to 0.0591 in.)

Toyota Tundra Service Manual > Air Conditioning System(for Automatic Air Conditioning System): Pressure Sensor Circuit (B1423/23)
DESCRIPTION This DTC is output when refrigerant pressure is extremely low (196 kPa (2.0 kgf/cm2, 28 psi) or less) or extremely high (3140 kPa (32.0 kgf/cm2, 455 psi) or more). The pressure switch, which is installed on the pipe of the high pressure side to detect refrigerant pressure, outputs a refr ...

Toyota Tundra Owners Manual