Toyota Tundra Service Manual: Hood Lock Control Cable Assembly

Toyota Tundra Service Manual / Vehicle Interior / Engine Hood / Door / Hood Lock Control Cable Assembly

Components

COMPONENTS

ILLUSTRATION

ILLUSTRATION

ILLUSTRATION

Installation

INSTALLATION

CAUTION / NOTICE / HINT

HINT:

A bolt without a torque specification is shown in the standard bolt chart (See page ).

PROCEDURE

1. INSTALL HOOD LOCK CONTROL CABLE ASSEMBLY

(a) Pass the hood lock control cable assembly into the engine room.

(b) Pass the rear end of the hood lock control cable assembly through the grommet until the cable stopper is attached to the grommet.

(c) Pass the front end of the hood lock control cable assembly through the upper radiator support.

(d) Attach the hood lock control cable assembly to the clamps as shown in the illustration.

Text in Illustration

*1

Hood Lock Control Cable Assembly

*2

Clamp

*3

Grommet

-

-

2. INSTALL HOOD LOCK CONTROL LEVER SUB-ASSEMBLY

(a) Connect the hood lock control cable assembly to the hood lock control lever sub-assembly.

(b) Attach the 3 claws to install the hood lock lever sub-assembly.

3. INSTALL HOOD LOCK ASSEMBLY

(a) Apply MP grease to the sliding areas of the hood lock assembly.

Text in Illustration

*a

Back Side

*b

Front Side

(b) Connect the hood lock control cable assembly.

(c) Install the hood lock assembly.

(d) Install the 2 bolts and hood lock bolt.

Torque:

8.0 N·m {82 kgf·cm, 71 in·lbf}

(e) Install a new hood lock nut cap.

(f) w/ Engine Hood Courtesy Switch:

(1) Connect the connector.

(2) Attach the clamp.

4. INSTALL RADIATOR GRILLE SUB-ASSEMBLY

Removal

REMOVAL

PROCEDURE

1. REMOVE RADIATOR GRILLE SUB-ASSEMBLY

2. REMOVE HOOD LOCK ASSEMBLY

(a) w/ Engine Hood Courtesy Switch:

(1) Disconnect the connector.

(2) Detach the clamp.

(b) Using a screwdriver, remove the hood lock nut cap.

HINT:

Tape the screwdriver tip before use.

Text in Illustration

*1

Protective Tape

(c) Remove the 2 bolts and hood lock bolt.

(d) Remove the hood lock assembly.

(e) Disconnect the hood lock control cable assembly.

3. REMOVE HOOD LOCK CONTROL LEVER SUB-ASSEMBLY

(a) Detach the 3 claws.

(b) Disconnect the hood lock control cable assembly and remove the hood lock control lever sub-assembly.

4. REMOVE HOOD LOCK CONTROL CABLE ASSEMBLY

(a) Using a screwdriver, detach the hood lock control cable assembly from the clamps as shown in the illustration.

HINT:

Tape the screwdriver tip before use.

(b) Pull the hood lock control cable assembly from the engine room and remove it.

Text in Illustration

*1

Hood Lock Control Cable Assembly

*2

Clamp

*3

Grommet

-

-

    Reassembly

    Hood Support

    See More:

    Toyota Tundra Service Manual > Seat Belt Warning System: Customize Parameters
    CUSTOMIZE PARAMETERS PROCEDURE 1. CUSTOMIZE SEAT BELT WARNING SYSTEM HINT: The following items can be customized. NOTICE: When the customer requests a change in a function, first make sure that the function can be customized. Be sure to make a note of the current settings before customizing. When tr ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2022 Copyright www.ttundra.com
    0.0177