Toyota Tundra Service Manual: Adjustment

ADJUSTMENT

CAUTION / NOTICE / HINT

HINT:

  • Centering bolts are used to mount the hood hinge and hood lock. The hood and hood lock cannot be adjusted with the centering bolts on. Substitute the centering bolts with standard bolts (with washers) when making adjustments.
  • A bolt without a torque specification is shown in the standard bolt chart (See page ).

PROCEDURE

1. ADJUST HOOD SUB-ASSEMBLY

(a) Adjust the hood sub-assembly position.

(1) Loosen the 4 hinge bolts.

(2) Move the hood sub-assembly and adjust the clearance between the hood sub-assembly and front fender.

(3) Tighten the 4 hinge bolts after the adjustment.

Torque:

13 N·m {133 kgf·cm, 10 ft·lbf}

(4) Adjust the cushion rubber so that the height of the hood sub-assembly and fender are aligned.

HINT:

Raise or lower the hood sub-assembly front end by turning the cushion rubber.

(b) Adjust the hood lock assembly.

(1) Using a screwdriver, remove the hood lock nut cap as shown in the illustration.

HINT:

Tape the screwdriver tip before use.

Text in Illustration

*1

Protective Tape

(2) Loosen the 2 bolts and hood lock bolt.

(3) Adjust the hood lock assembly position so that the striker can enter it smoothly.

(4) Tighten the bolts after the adjustment.

Torque:

8.0 N·m {82 kgf·cm, 71 in·lbf}

(5) Install a new hood lock nut cap.

    Hood

    Components

    See More:

    Toyota Tundra Service Manual > Pre-collision System: System Diagram
    SYSTEM DIAGRAM Communication Table Sender Receiver Signal Line Millimeter Wave Radar Sensor Assembly Forward Recognition Camera Pre-collision alarm signal Pre-collision braking operation signal CAN Skid Control ECU (Brake Actuator Assembly) Brake assist standby signal Pre-collision braking operation ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2022 Copyright www.ttundra.com
    0.0101