Toyota Tundra Service Manual: On-vehicle Inspection

Toyota Tundra Service Manual / Vehicle Interior / Engine Hood / Door / Hood / On-vehicle Inspection

ON-VEHICLE INSPECTION

PROCEDURE

1. INSPECT HOOD SUB-ASSEMBLY

(a) Check that the clearance measurements of areas A to D are within the standard range.

Standard Clearance:

Area

Specified Condition

A

3.7 to 6.7 mm (0.146 to 0.264 in.)

B

-1.5 to 1.5 mm (-0.0591 to 0.0591 in.)

C

(Reference)

25.25 to 28.25 mm (0.995 to 1.113 in.)

D

(Reference)

5.6 to 8.6 mm (0.220 to 0.339 in.)
    Disassembly

    Reassembly

    See More:

    Toyota Tundra Service Manual > Steering Knuckle: Removal
    REMOVAL CAUTION / NOTICE / HINT HINT: Use the same procedures for the LH side and RH side. The procedures listed below are for the LH side. PROCEDURE 1. REMOVE FRONT AXLE HUB SUB-ASSEMBLY LH (a) Remove the front axle hub (see page ). 2. DISCONNECT FRONT SPEED SENSOR LH (a) Remove the clip and bolt. ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2026 Copyright www.ttundra.com
    0.0311