ADJUSTMENT CAUTION / NOTICE / HINT HINT:
PROCEDURE 1. ADJUST REAR DOOR (a) Disconnect the cable from the negative (-) battery terminal. CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation. NOTICE:
(b) Loosen the body's hinge bolts and adjust the door's position. (c) Tighten the body's hinge bolts after the adjustment. Torque: 29 N·m {296 kgf·cm, 21 ft·lbf} (d) Loosen the door's hinge bolts and adjust the door's position. (e) Tighten the door's hinge bolts after the adjustment. Torque: 29 N·m {296 kgf·cm, 21 ft·lbf} (f) Using a screwdriver, detach the 4 claws and remove the cover. HINT: Tape the screwdriver tip before use.
(h) Using a T40 "TORX" socket, tighten the striker mounting screws after the adjustment. Torque: 23 N·m {235 kgf·cm, 17 ft·lbf} (i) Connect the cable to the negative (-) battery terminal. NOTICE: Some systems need to be initialized after the cable is reconnected (see page ). (j) Inspect the SRS warning light (see page ). |
Toyota Tundra Service Manual > Sfi System: VIN not Programmed or Mismatch - ECM / PCM (P0630)
DESCRIPTION DTC P0630 is stored when the Vehicle Identification Number (VIN) is not stored in the Engine Control Module (ECM) or the input VIN is incorrect. Input the VIN with the Techstream. DTC No. DTC Detection Condition Trouble Area P0630 When either condition below is met: (1 trip detection log ...