Toyota Tundra Service Manual: On-vehicle Inspection

ON-VEHICLE INSPECTION

PROCEDURE

1. INSPECT REAR DOOR PANEL SUB-ASSEMBLY LH

(a) Check that the clearance measurements of areas A to J are within the standard range.

Standard measurement:

Area

Specified Condition

Area

Specified Condition

A

4.7 to 7.7 mm (0.185 to 0.303 in.)

F

2.5 to 5.5 mm (0.0984 to 0.217 in.)

B

-1.5 to 1.5 mm (-0.0591 to 0.0591 in.)

G

3.5 to 6.5 mm (0.138 to 0.256 in.)

C

3.2 to 6.2 mm (0.126 to 0.244 in.)

H

-1.4 to 1.6 mm (0.0551 to 0.0630 in.)

D

2.7 to 5.7 mm (0.106 to 0.224 in.)

I

4.0 to 7.0 mm (0.156 to 0.277 in.)

E

3.2 to 6.2 mm (0.126 to 0.244 in.)

J

-1.1 to 1.9 mm (-0.0433 to 0.0748 in.)

    Disassembly

    Reassembly

    See More:

    Toyota Tundra Service Manual > Forward Recognition Camera System: Precaution
    PRECAUTION PRECAUTION WHEN REPLACING COMBINATION METER ASSEMBLY (a) When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in it will not match the information from the ve ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2022 Copyright www.ttundra.com
    0.009