Toyota Tundra Service Manual: Dtc Check / Clear

DTC CHECK / CLEAR

CHECK FOR TRANSPONDER KEY ECU ASSEMBLY DTC

(a) Connect the Techstream to the DLC3.

(b) Turn the ignition switch to ON.

(c) Turn the Techstream on.

(d) Enter the following menus: Body Electrical / Immobiliser / Trouble Codes.

(e) Check for DTCs.

CHECK FOR ECM DTC

(a) Connect the Techstream to the DLC3.

(b) Turn the ignition switch to ON.

(c) Turn the Techstream on.

(d) Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.

(e) Check for DTCs.

CLEAR TRANSPONDER KEY ECU ASSEMBLY DTC

(a) Connect the Techstream to the DLC3.

(b) Turn the ignition switch to ON.

(c) Turn the Techstream on.

(d) Enter the following menus: Body Electrical / Immobiliser / Trouble Codes.

(e) Clear the DTCs.

CLEAR ECM DTC

(a) Connect the Techstream to the DLC3.

(b) Turn the ignition switch to ON.

(c) Turn the Techstream on.

(d) Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.

(e) Clear the DTCs.

    Diagnostic Trouble Code Chart

    Engine does not Start because No Initial Combustion

    See More:

    Toyota Tundra Service Manual > Instrument Panel Safety Pad(for Floor Shift Type): Installation
    INSTALLATION CAUTION / NOTICE / HINT HINT: A bolt without a torque specification is shown in the standard bolt chart (See page ). PROCEDURE 1. INSTALL NO. 1 INSTRUMENT PANEL CLIP 2. INSTALL NO. 3 INSTRUMENT PANEL STAY 3. INSTALL INSTRUMENT PANEL SUB-ASSEMBLY (a) Set the instrument panel sub-assembly ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2025 Copyright www.ttundra.com
    0.0247