Toyota Tundra Service Manual: Transponder Key Amplifier

Components

COMPONENTS

ILLUSTRATION

*A	for Column Shift Type	-	-
*1	LOWER STEERING COLUMN COVER	*2	TRANSPONDER KEY COIL

ILLUSTRATION

*A	for Floor Shift Type	-	-
*1	LOWER STEERING COLUMN COVER	*2	TRANSPONDER KEY COIL

Installation

INSTALLATION

PROCEDURE

1. INSTALL TRANSPONDER KEY COIL

(a) Align the transponder key coil with the installation position of the upper bracket with the amplifier inclined.

(b) Push the transponder key coil and install it to the upper bracket.

NOTICE:

Do not push the transponder key coil upward with excessive force.

2. INSTALL LOWER STEERING COLUMN COVER

(a) Attach the 2 claws to install the lower steering column cover.

(b) Install the 2 screws.

Removal

REMOVAL

PROCEDURE

1. REMOVE LOWER STEERING COLUMN COVER

(a) While turning the steering wheel to the right and left, remove the 2 screws.

(b) Detach the 2 claws and remove the lower steering column cover.

2. REMOVE TRANSPONDER KEY COIL

(a) Disconnect each connector.

(b) Using a screwdriver, widen the claws attached to the upper bracket by approximately 1 mm (0.0394 in.).

NOTICE:

Take care not to apply excessive force to prevent the case from being damaged.

Toyota Tundra Service Manual > Dynamic Radar Cruise Control System: Lost Communication with ECM / PCM "A" (U0100,U0104,U0122,U0125,U0126,U0129,U0137)
DESCRIPTION The millimeter wave radar sensor assembly and ECM communicate with each sensor and ECU via CAN communication. If any malfunction is detected in a CAN communication circuit, one or more CAN communication system DTCs are stored. DTC No. Detection Item DTC Detection Condition Trouble Area U ...

Toyota Tundra Owners Manual