Toyota Tundra Service Manual: Reassembly

REASSEMBLY

PROCEDURE

1. INSTALL REAR BUMPER UPPER COVER LH

(a) Install the rear bumper upper cover LH with the 2 nuts.

Torque:

30 N·m {306 kgf·cm, 22 ft·lbf}

2. INSTALL REAR BUMPER UPPER COVER RH

HINT:

Use the same procedure described for the LH side.

3. INSTALL REAR BUMPER BAR LH

(a) Install the rear bumper bar LH with the 5 bolts.

Torque:

30 N·m {306 kgf·cm, 22 ft·lbf}

4. INSTALL REAR BUMPER BAR RH

HINT:

Use the same procedure described for the LH side.

5. INSTALL REAR BUMPER PLATE

(a) Install the rear bumper plate with the 2 bolts.

Torque:

30 N·m {306 kgf·cm, 22 ft·lbf}

6. INSTALL NO. 2 FRAME WIRE

(a) w/ Towing Package:

(1) Attach all the clamps to install the No. 2 frame wire to the receiver hitch bracket sub-assembly.

(b) w/o Towing Package:

(1) Attach all the clamps to install the No. 2 frame wire to the rear bumper reinforcement sub-assembly.

7. INSTALL NO. 3 ULTRASONIC SENSOR (w/ Intuitive Parking Assist System)

8. INSTALL NO. 2 ULTRASONIC SENSOR RETAINER (w/ Intuitive Parking Assist System)

9. INSTALL NO. 2 ULTRASONIC SENSOR (w/ Intuitive Parking Assist System)

10. INSTALL REAR BUMPER BAR CORNER REINFORCEMENT LH

(a) Install the rear bumper bar corner reinforcement LH with the 5 bolts.

Torque:

30 N·m {306 kgf·cm, 22 ft·lbf}

11. INSTALL REAR BUMPER BAR CORNER REINFORCEMENT RH

HINT:

Use the same procedure described for the LH side.

12. INSTALL LICENSE PLATE LIGHT ASSEMBLY LH

13. INSTALL LICENSE PLATE LIGHT ASSEMBLY RH

HINT:

Use the same procedure described for the LH side.

14. INSTALL REAR BUMPER PAD SUB-ASSEMBLY LH

(a) Attach the 12 claws and 2 guides to install a new rear bumper pad sub-assembly LH.

(b) Install the 3 clips.

15. INSTALL REAR BUMPER PLATE LH

(a) Attach the 3 claws and clip to install a new rear bumper plate LH.

16. INSTALL REAR BUMPER PLATE RH

HINT:

Use the same procedure described for the LH side.

    Installation

    Removal

    See More:

    Toyota Tundra Service Manual > Steering Column Assembly(for Manual Tilt And Manual Telescopic Steering Column): Inspection
    INSPECTION PROCEDURE 1. INSPECT STEERING COLUMN ASSEMBLY (a) Measure the length of the steering main shaft. Standard length(A): 529.5 mm (1.74 ft.) (b) Inspect the bushings. (1) Check that the 2 bushings are securely installed to the steering column assembly. Text in Illustration *1 Bushing If the b ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2022 Copyright www.ttundra.com
    0.0194