Toyota Tundra Service Manual: Rear Door Belt Moulding(for Crewmax)

Toyota Tundra Service Manual / Vehicle Interior / Exterior / Rear Door Belt Moulding(for Crewmax)

Components

COMPONENTS

ILLUSTRATION

Installation

INSTALLATION

CAUTION / NOTICE / HINT

HINT:

  • Use the same procedures for the RH side and LH side.
  • The procedures listed below are for the LH side.

PROCEDURE

1. INSTALL REAR OUTER DOOR GLASS WEATHERSTRIP LH

(a) Attach the claw to install the weatherstrip.

2. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY LH

3. INSTALL REAR DOOR ARMREST COVER LH

4. INSTALL REAR DOOR FRAME GARNISH LH

5. INSTALL REAR UPPER DOOR ARMREST BASE PANEL LH

6. INSTALL REAR DOOR INSIDE HANDLE BEZEL PLUG LH

Removal

REMOVAL

CAUTION / NOTICE / HINT

HINT:

  • Use the same procedures for the RH side and LH side.
  • The procedures listed below are for the LH side.

PROCEDURE

1. REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG LH

2. REMOVE REAR UPPER DOOR ARMREST BASE PANEL LH

3. REMOVE REAR DOOR FRAME GARNISH LH

4. REMOVE REAR DOOR ARMREST COVER LH

5. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY LH

6. REMOVE REAR OUTER DOOR GLASS WEATHERSTRIP LH

(a) Put protective tape around the weatherstrip outer.

(b) Using a moulding remover, detach the claw and remove the weatherstrip.

    Removal

    Rear Door Belt Moulding(for Double Cab)

    See More:

    Toyota Tundra Service Manual > Sfi System: Evaporative Emission Pressure Switching Valve Stuck OFF (P2420)
    DTC SUMMARY DTC No. Monitoring Item Malfunction Detection Condition Trouble Area Detection Timing Detection Logic P2420 Vent valve stuck open (vent) Following condition met during key-off EVAP monitor: EVAP pressure change when vent valve closed (ON) less than 0.3 kPa-g (2.25 mmHg-g) Canister pump m ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2026 Copyright www.ttundra.com
    0.0307