REMOVAL CAUTION / NOTICE / HINT HINT:
Standard heating temperature:
NOTICE: Do not heat the vehicle body, moulding and clip excessively. PROCEDURE 1. REMOVE REAR ROOF DRIP SIDE FINISH MOULDING LH (a) Put protective tape around the moulding. (b) Using a heat light, heat the moulding. NOTICE: Do not heat the moulding and vehicle body excessively. (c) Using a moulding remover, detach the clip and remove the moulding. NOTICE:
2. REMOVE ROOF DRIP SIDE FINISH MOULDING LH (a) Put protective tape around the moulding. (b) Using a moulding remover, detach the clip and remove the moulding. NOTICE:
3. REMOVE ROOF DRIP SIDE FINISH MOULDING CLIP HINT: Perform the following procedure only if the clips are damaged or have come off the vehicle. (a) Remove the 2 roof drip side finish moulding clips.
|
Toyota Tundra Service Manual > Sfi System: Fuel Injector Circuit
DESCRIPTION The fuel injectors are located on the intake manifold. They inject fuel into the cylinders based on the signals from the ECM. WIRING DIAGRAM PROCEDURE 1. INSPECT FUEL INJECTOR ASSEMBLY (POWER SOURCE) (a) Disconnect the fuel injector assembly connector. (b) Turn the ignition switch to ON. ...