Toyota Tundra Service Manual: Low Pitched Horn

Components

COMPONENTS

ILLUSTRATION

*A	Type A	*B	Type B
*C	Type C	-	-
*1	LOW PITCHED HORN ASSEMBLY	*2	RADIATOR GRILLE SUB-ASSEMBLY
	Nm (kgfcm, ft.*lbf): Specified torque	-	-

Inspection

INSPECTION

PROCEDURE

1. INSPECT LOW PITCHED HORN ASSEMBLY

(a) Apply battery voltage and check operation of the low pitched horn assembly, as shown in the table.

OK:

Measurement Condition

Specified Condition

Battery positive (+) → Terminal 1

Battery negative (-) → Body ground

Low pitched horn assembly sounds

If the result is not as specified, replace the low pitched horn assembly.

Installation

INSTALLATION

PROCEDURE

1. INSTALL LOW PITCHED HORN ASSEMBLY

(a) Install the low pitched horn assembly with the bolt.

Torque:

20 N·m {199 kgf·cm, 14 ft·lbf}

(b) Connect the connector.

2. INSTALL RADIATOR GRILLE SUB-ASSEMBLY

Click here

Removal

REMOVAL

PROCEDURE

1. REMOVE RADIATOR GRILLE SUB-ASSEMBLY

Click here

2. REMOVE LOW PITCHED HORN ASSEMBLY

(a) Disconnect the connector.

(b) Remove the bolt and low pitched horn assembly.

Toyota Tundra Service Manual > Sfi System: Camshaft Position "A" Actuator Circuit (Bank 1) (P0010,P0020)
DESCRIPTION This DTC is designed to detect opens or shorts in the camshaft oil control valve (OCV) circuit. If the OCV's duty-cycle is excessively high or low while the engine is running, the ECM will illuminate the MIL and store the DTC. The VVT (variable valve timing) system adjusts the intake and ...

Toyota Tundra Owners Manual