Toyota Tundra Service Manual: Daytime Running Light Relay

Toyota Tundra Service Manual / Vehicle Interior / Lighting / Daytime Running Light Relay

On-vehicle Inspection

ON-VEHICLE INSPECTION

PROCEDURE

1. INSPECT NO. 1 DAY TIME RUNNING LIGHT RELAY

(a) Remove the No. 1 day time running light relay from the engine room relay box.

(b) Check the resistance.

(1) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

3 - 5

Battery voltage not applied to terminals 1 and 2

10 kΩ or higher

Battery voltage applied to terminals 1 and 2

Below 1 Ω

If the result is not as specified, replace the No. 1 day time running light relay.

(c) Install the No. 1 day time running light relay to the engine room relay box.

    Removal

    Door Mirror Foot Light

    See More:

    Toyota Tundra Service Manual > Exterior: Fender Liner(for Rear Side)
    Components COMPONENTS ILLUSTRATION Installation INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH and LH sides. The procedures listed below are for the LH side. PROCEDURE 1. INSTALL REAR WHEEL HOUSE LINER LH (a) Install the rear wheel house liner LH with 22 new grommets. ( ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2024 Copyright www.ttundra.com
    0.0352