Toyota Tundra Service Manual: Installation

INSTALLATION

CAUTION / NOTICE / HINT

HINT:

  • Use the same procedure for the RH and LH sides.
  • The procedure listed below is for the LH side.
  • A bolt without a torque specification is shown in the standard bolt chart (See page ).

PROCEDURE

1. INSTALL HEADLIGHT ASSEMBLY LH

(a) Put protective tape around the headlight assembly LH.

Text in Illustration

*1

Protective Tape

(b) Connect each connector and attach the clamp.

(c) Attach the claw to install the headlight assembly LH.

(d) Install the 2 screws and bolt.

2. INSTALL FRONT END PANEL LH

3. INSTALL RADIATOR GRILLE SUB-ASSEMBLY

4. ADJUST HEADLIGHT AIMING

(See page )

    Disassembly

    Reassembly

    See More:

    Toyota Tundra Service Manual > Trailer Brake Control System: Terminals Of Ecu
    TERMINALS OF ECU 1. CHECK TRAILER BRAKE CONTROL ECU (BRAKE CONTROL WITH BRACKET RELAY) (a) Disconnect the J172 trailer brake control ECU (brake control with bracket relay) connector and measure the voltage or resistance on the wire harness side. Text in Illustration *a Front view of wire harness con ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2024 Copyright www.ttundra.com
    0.0121