Toyota Tundra Service Manual: Headlight Relay

On-vehicle Inspection

ON-VEHICLE INSPECTION

PROCEDURE

1. INSPECT HEADLIGHT RELAY

(a) Remove the headlight relay from the engine room relay box.

(b) Check the resistance.

(1) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

3 - 5

Battery voltage not applied to terminals 1 and 2

10 kΩ or higher

Battery voltage applied to terminals 1 and 2

Below 1 Ω

If the result is not as specified, replace the headlight relay.

(c) Install the headlight relay to the engine room relay box.

    Removal

    High Beam Main Switch

    See More:

    Toyota Tundra Service Manual > Blind Spot Monitor System: Open in Outer Mirror Indicator(Slave) (C1AB5)
    DESCRIPTION This DTC is stored when the blind spot monitor sensor LH detects an open in the outer rear view mirror indicator LH. DTC No. DTC Detection Condition Trouble Area C1AB5 Both of the following conditions are met: The blind spot monitor system is on The current flowing to the indicator is be ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2024 Copyright www.ttundra.com
    0.0095