Toyota Tundra Service Manual: Lost Communication with ECM / PCM "A" (U0100)

Toyota Tundra Service Manual / Vehicle Interior / Meter / Gauge / Display / Meter / Gauge System / Lost Communication with ECM / PCM "A" (U0100)

DESCRIPTION

The combination meter communicates with the ECM via the CAN line.

DTC Code

DTC Detection Condition

Trouble Area

U0100

When either of following conditions is detected:

  • Vehicle speed 5 km/h (3 mph) or more and IG voltage 10.5 V or more
  • No communication with ECM continues for 3 seconds or more (No communication to ECM or skid control ECU continues for 60 seconds or more)

CAN communication system

WIRING DIAGRAM

PROCEDURE

1.

CHECK FOR DTC

(a) Check for DTCs and note any codes that are output (See page ).

(b) Clear the DTC (See page ).

(c) Recheck for DTC (See page ).

Result

Result

Proceed to

DTC U0100 is not output

A

DTC U0100 is output

B

HINT:

If the CAN communication system DTC U0100 and another DTC are output at the same time, perform troubleshooting for the CAN communication system DTC U0100 first.

A

USE SIMULATION METHOD TO CHECK

B

Go to CAN COMMUNICATION SYSTEM

    Lost Communication with Front Camera Module (U023A)

    Lost Communication with Brake System Control Module (U0129)

    See More:

    Toyota Tundra Service Manual > Audio And Visual System: Data Signal Circuit between Radio Receiver and Stereo Jack Adapter
    DESCRIPTION The No. 1 stereo jack adapter assembly sends the sound data signal or image data signal from a device to the radio and display receiver assembly via this circuit. WIRING DIAGRAM PROCEDURE 1. CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - NO. 1 STEREO JACK ADAPTER ASSE ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2024 Copyright www.ttundra.com
    0.0114