Components COMPONENTS ILLUSTRATION Installation INSTALLATION PROCEDURE 1. INSTALL CHILD RESTRAINT SEAT TETHER ANCHOR BRACKET (a) Align the holes with the positioning pins and install the 3 anchor brackets with the 3 bolts. Torque: 42 N·m {428 kgf·cm, 31 ft·lbf} 2. INSTALL REAR SEAT ASSEMBLY (a) Install the rear seat (see page ). Removal REMOVAL PROCEDURE 1. REMOVE REAR SEAT ASSEMBLY (a) Remove the rear seat (see page ). 2. REMOVE CHILD RESTRAINT SEAT TETHER ANCHOR BRACKET (a) Remove the 3 bolts and 3 anchor brackets. |
Toyota Tundra Service Manual > Engine Immobiliser System (w/o Smart Key System): Terminals Of Ecu
TERMINALS OF ECU CHECK TRANSPONDER KEY ECU ASSEMBLY (a) Disconnect the J26 transponder key ECU assembly connector. (b) Measure the resistance and voltage according to the value(s) in the table below. HINT: Measure the values on the wire harness side with the connector disconnected. Tester Connection ...