DISASSEMBLY PROCEDURE 1. REMOVE SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY (a) Remove the 2 bolts, room light bracket and drive gear. 2. REMOVE SUNSHADE TRIM SUB-ASSEMBLY (a) Remove the 2 screws. (b) Detach the 4 claws and remove the sliding roof piece LH and RH. (c) Slide and remove the trim. 3. REMOVE SLIDING ROOF DRIVE CABLE SUB-ASSEMBLY NOTICE: Do not disassemble the sliding roof drive cable sub-assembly except when replacing it.
(c) Slide each roof wind deflector lifter link in the direction indicated by the arrow in the illustration to remove it.
(e) Place matchmarks on the sliding roof drive cable sub-assembly and sliding roof housing sub-assembly.
4. REMOVE REAR SLIDING ROOF HOUSING MOUNTING BRACKET LH
5. REMOVE REAR SLIDING ROOF HOUSING MOUNTING BRACKET RH HINT: Use the same procedures described for the LH side. |
Toyota Tundra Service Manual > Can Communication System: Check Bus 4 Line for Short to +B
DESCRIPTION There may be a short circuit between one of the CAN bus lines and +B when there is no resistance between terminal 22 (CA2H) of the central gateway ECU (network gateway ECU) and terminal 16 (BAT) of the DLC3, or terminal 7 (CA2L) of the central gateway ECU (network gateway ECU) and termin ...