Toyota Tundra Service Manual: Sliding Roof Switch Assembly(for Crewmax)

Toyota Tundra Service Manual / Vehicle Interior / Sliding Roof / Sliding Roof Switch Assembly(for Crewmax)

Components

COMPONENTS

ILLUSTRATION

Inspection

INSPECTION

PROCEDURE

1. INSPECT SLIDE ROOF MOTOR SWITCH

(a) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Switch Condition

Specified Condition

1 (UP) - 5 (E)

Tilt switch is pressed to up

Below 1 Ω

1 (UP) - 5 (E)

Tilt switch is not pressed to up

10 kΩ or higher

2 (DOWN) - 5 (E)

Tilt switch is pressed to down

Below 1 Ω

2 (DOWN) - 5 (E)

Tilt switch is not pressed to down

10 kΩ or higher

4 (OPN) - 5 (E)

Slide switch is pressed to open

Below 1 Ω

4 (OPN) - 5 (E)

Slide switch is not pressed to open

10 kΩ or higher

3 (CLS) - 5 (E)

Slide switch is pressed to close

Below 1 Ω

3 (CLS) - 5 (E)

Slide switch is not pressed to close

10 kΩ or higher

If the result is not as specified, replace the slide roof motor switch.

Text in Illustration

*1

Tilt Switch

*2

Slide Switch

*a

Up

*b

Down

*c

Open

*d

Close

*e

Component without harness connected

(Slide Roof Motor Switch)

Installation

INSTALLATION

PROCEDURE

1. INSTALL SLIDE ROOF MOTOR SWITCH

(a) Attach the 4 claws to install the slide roof motor switch.

(b) Connect the connector.

(c) Attach the 8 claws to install the roof console box base.

Removal

REMOVAL

PROCEDURE

1. REMOVE SLIDE ROOF MOTOR SWITCH

(a) Put protective tape around the roof console box base.

Text in Illustration

*1

Protective Tape

(b) Using a screwdriver, detach the 8 claws.

HINT:

Tape the screwdriver tip before use.

(c) Disconnect the connector and remove the roof console box base.

(d) Detach the 4 claws and remove the slide roof motor switch.
    Removal

    Sliding Roof System

    See More:

    Toyota Tundra Service Manual > Outer Rear View Mirror: Inspection
    INSPECTION PROCEDURE 1. INSPECT OUTER REAR VIEW MIRROR ASSEMBLY LH (for Standard) (a) Check the outer mirror motor operation. (1) Apply battery voltage and check operation of the mirror face. OK: Battery Connection Specified Condition Positive (+) → 10 (MV) Negative (-) → 11 (M+) Turns upward (A ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2024 Copyright www.ttundra.com
    0.0191