Toyota Tundra Service Manual: Inspection

INSPECTION

PROCEDURE

1. INSPECT FRONT NO. 2 SPEAKER ASSEMBLY (for Standard)

(a) When there is a malfunction such as noise from a speaker or no sound at all, replace the speaker with a new one and check that the malfunction disappears.

OK:

Malfunction disappears.

HINT:

  • Connect the connectors to the front No. 2 speaker assemblies.
  • When there is a possibility that either the right or left front No. 2 speaker assembly is defective, inspect by interchanging the right one with the left one.
  • Perform the inspection above on both the LH and RH sides.

2. INSPECT FRONT NO. 2 SPEAKER ASSEMBLY (for 12 Speakers)

(a) Measure the resistance according to the value(s) in the table below.

Standard resistance:

Tester Connection

Condition

Specified Condition

3 - 4

Always

1.5 to 2.5 Ω

3 - 1

Always

Below 1 Ω

4 - 2

If the result is not as specified, replace the front No. 2 speaker assembly.

Text in Illustration

*a

Component without harness connected

(Front No. 2 Speaker Assembly)

3. INSPECT FRONT NO. 4 SPEAKER ASSEMBLY (for Standard)

(a) Temporarily replace the front No. 4 speaker assembly with a new or normally functioning one.

OK:

Malfunction disappears.

HINT:

Connect the connectors to the front No. 4 speaker assembly.

4. INSPECT FRONT NO. 4 SPEAKER ASSEMBLY (for 12 Speakers)

(a) Measure the resistance according to the value(s) in the table below.

Standard resistance:

Tester Connection

Condition

Specified Condition

1 - 2

Always

1.5 to 2.1 Ω

If the result is not as specified, replace the front No. 4 speaker assembly.

Text in Illustration

*a

Component without harness connected

(Front No. 4 Speaker Assembly)

    Components

    Installation

    See More:

    Toyota Tundra Service Manual > Blind Spot Monitor System: Blind Spot Monitor Master Module Beam Axis Inspection Incomplete (C1ABB)
    DESCRIPTION This DTC is stored when a beam axis inspection has not been performed for the blind spot monitor sensor RH. HINT: This DTC is always stored after replacing a blind spot monitor sensor. The purpose of this DTC is to ensure that beam axis inspection is performed. Completing the beam axis i ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2022 Copyright www.ttundra.com
    0.0043