INITIALIZATION 1. INITIALIZE SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY NOTICE: When replacing the sliding roof drive gear, the new sliding roof drive gear requires initialization. If a reset is not executed, the following functions do not operate: AUTO operation and jam protection function. (a) Turn the ignition switch ON. (b) By pushing the SLIDE switch to close or the TILT switch to up on the roof console box, make the sliding roof operate as follows: TILT UP → approximately 1 second → TILT UP (The sliding roof lowers a little after it is fully tilted up.) (c) Check that the sliding roof stops at the fully closed position. (d) Finish the initialization. (e) Check that the AUTO operation works normally. NOTICE: If the following conditions occur while operating, initialization will fail.
HINT:
|
Toyota Tundra Service Manual > Front Seat Side Airbag Assembly(for Manual Seat): Installation
INSTALLATION CAUTION / NOTICE / HINT CAUTION: Wear protective gloves. Sharp areas on the seat frame and adjuster may injure your hands. PROCEDURE 1. INSTALL FRONT SEAT AIRBAG ASSEMBLY LH CAUTION: The nuts must not be reused. Make sure that the front seat back main frame sub-assembly is not deformed. ...