ON-VEHICLE INSPECTION PROCEDURE 1. CHECK CENTER AIRBAG SENSOR ASSEMBLY (VEHICLE NOT INVOLVED IN COLLISION) (a) Perform a diagnostic system check (see page ). 2. CHECK CENTER AIRBAG SENSOR ASSEMBLY (VEHICLE INVOLVED IN COLLISION AND AIRBAG HAS NOT DEPLOYED) (a) Perform a diagnostic system check (see page ). 3. CHECK CENTER AIRBAG SENSOR ASSEMBLY (VEHICLE INVOLVED IN COLLISION AND AIRBAG IS DEPLOYED) (a) Replace the center airbag sensor. CAUTION: For removal and installation procedures of the center airbag sensor, be sure to follow the correct procedure. HINT: The center airbag sensor should be replaced after any of the airbags has deployed, as it has been subjected to the impact. |
Toyota Tundra Service Manual > Cylinder Block: Reassembly
REASSEMBLY CAUTION / NOTICE / HINT HINT: Perform "Inspection After Repairs" after replacing the piston or piston ring (See page ). PROCEDURE 1. INSTALL STUD BOLT (a) Using an E8 "TORX" socket wrench, install the stud bolts. Torque: for stud bolt A : 20 N·m {204 kgf·cm, 15 ft·lbf} for stud bolt B ...